Additional Armour Plate Strips (10).
Each strip should be separated into three plates. These are great for reinforcing the vulnerable waist of a 28mm Heroic Armoured figure, but can also be used anywhere else where reinforcement is needed!
Each plate, when cut from the strip, measures 4.7mm across the top, 4.3mm across the bottom and is 3.5mm high.
The strip should be carefully cut in to three separate plates by placing a craft knife along the joint between the plates and carefully pressing through to your cutting mat, place a cloth or similar over the area to stop the plates flying off around the room!
Part of our conversion bits range, perfect for sci-fi or fantasy wargaming.
This product is not a toy and is unsuitable for under 14's. They are supplied unpainted, and will require some preparation and assembly with super glue.
We recommend testing the poses and assembly of each miniature in the set before glueing in place. Some components can be left unglued, be magnetised or held in place with Blu-Tac or similar to allow weapon changes.
For further guidance please see the 'Working with Resin' guide at the bottom of the page.