• Armour Plates for Wargame Miniatures (10)

Additional Armour Plate Strips (10).

Each strip should be separated into three plates. These are great for reinforcing the vulnerable waist of a 28mm Heroic Armoured figure, but can also be used anywhere else where reinforcement is needed!  

Each plate, when cut from the strip, measures 4.7mm across the top, 4.3mm across the bottom and is 3.5mm high.

The strip should be carefully cut in to three separate plates by placing a craft knife along the joint between the plates and carefully pressing through to your cutting matt, place a cloth or similar over the area to stop the plates flying off around the room!

Part of our conversion bits range, perfect for sci-fi or fantasy wargaming.

This product is not a toy, it is  supplied unpainted, and will require some preparation and gluing with superglue. For further guidance, the Anvil Industry guide “Working with Resin” can be found at the bottom of the page.

Write a review

Please login or register to review

Armour Plates for Wargame Miniatures (10)

  • Product Code: A-T-EA
  • Availability: In Stock
  • £2.00

Tags: Bits

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.


* E-Mail: